Two Red Lights On Raycon Case (2024)

FAQs

What do two red lights on a Raycon case mean? ›

It has four LED indicator lights on the case to indicate its charge. Two extremity lights turn red to tell you when the buds are charging. If you need to reset the headphones, you can press the button located inside the case.

The LED color will indicate capsule battery. Once fully charged, the LED will stay green.

Charging Your Device

Note: When the Battery is low, a sound prompt will play, followed by a blinking red light. 5. Allow up to 3 hours to fully charge. The Impact speaker can last up to 15 hours on a single charge!

A blinking red light means the case has less than 25 percent left. When the case is plugged in, solid red shows when it's charging, and the light changes to green when that's complete. Last, a blue light pulses when the earbuds are charging, and it goes off when that process is complete.

A solid red light on your Bluetooth headphones indicates that the headphones are charging or are in need of charging, or there might be an issue with the device itself. Connect the headphones to a power source using the provided charging cable and let them charge for a while, even if they seem fully charged.

To fully charge the earbuds in the case you'll need an hour, while the case itself usually takes 2-3 hours to charge completely.

The earbud battery indicator is located inside the charging case and indicates the charging status of the earbuds. The charging case battery indicator is located on the front of the charging case and indicates the charging status of the charging case itself.

56 HOURS OF BATTERY LIFE

Listen for up to 12 hours with ANC off, take on any challenge with peace of mind that your earbuds will not fail. Reset, recharge, and go one more!

You may encounter that charging stops, does not start at all or that one of the ear buds suddenly switches on and begins the pairing process. This is almost always caused by dirt on the metal charging contacts. These contacts are vulnerable because they can easily be contaminated by sweat, skin grease, or ear wax.

Ensure indicator lights are on. Open the case and remove both earbuds. They will automatically turn on. Turn on Bluetooth and pair to“Raycon E50 Eardrums”.

Why is the red and white light flashing on my Bose earbuds? ›

The battery LED flashing red and white is indicating an internal fault. Try the following: Try charging your product for a few minutes. If the battery level is very low, your product might go into a battery protection state.

The LED lighting on the front will indicate current charging case power and then blink signaling that it is charging.

When charging, the Capsule LED will start to breathe. The LED color will indicate capsule battery. Once fully charged, the LED will stay green.

Check the battery level: If the battery level of either the headphones or your connected device is low, it can cause the connection to be weak or to drop. Reconnect your headphones by either turning them off and turning them back on or forgetting the Fitness Headphones from your device and re-pair.

Raycon Comparison Chart

Anywhere and everywhere, you can speak freely and be heard with our clear voice mode. Awareness mode so that you can hear what's going on around you while still enjoying the soundtrack of your life!

A red light on the earbuds will indicate they are being charged. A blue light on the earbuds will indicate they are full charged. This light will go o once the earbuds get fully charged.

Up to 8 hours playtime on a single charge. The charging capsule charges your earbuds up to 3 times while on the go.

RED light ON: Power OFF, charger connected and charging. BLUE light flashing: Power ON, no Bluetooth connected. Constant BLUE light: Power ON, connected to Bluetooth device.